12
GB
sanding/grinding paper coincide with the
oscillating plate.
Use of sanding/grinding paper without the
appropriate dimensions and perforations (Fig. 7/8):
Cut the sanding/grinding paper to fit the
corresponding dimensions.
Fit the sanding/grinding paper to the
sanding/grinding plate as described above.
Place the rectangular sanding/grinding plate (6)
together with the fitted sanding/grinding paper (a)
onto the punch (9) for the sanding/grinding
paper). (Fig. 8)
Now punch the required holes into the
sanding/grinding paper.
Remove the punch (9) from the sanding/grinding
plate (6).
Check the correct position of the punch holes in
the sanding/grinding paper.plate.
5.5.2 Fasting the sanding/grinding paper with
Velcro fastening system
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the
extraction holes on the sanding/grinding paper and
the sanding/grinding disk are aligned.
5.6 Triangular sanding/grinding plate (Fig. 6)
Fit the triangular sanding/grinding plate (8) to use the
equipment as delta sander/grinder.
Fastening the sanding/grinding paper:
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the vacuum
extraction holes on the sanding/grinding paper and
the sanding/grinding disk are aligned.
5.7 Eccentric sanding/grinding plate (Fig. 6)
Fit the eccentric sanding/grinding plate (7) to use the
equipment as eccentric sander/grinder.
Fastening the sanding/grinding paper:
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the vacuum
extraction holes on the sanding/grinding paper and
the sanding/grinding disk are aligned.
6. Operation
6.1 Switching the equipment ON/OFF
(Fig. 9/Item 2)
To switch on: Slide the ON/OFF switch (2) forwards
(position I)
To switch off: Slide the ON/OFF switch (2)
backwards (position 0)
6.2 Speed control (Fig. 7/Item 3)
To pre-select the speed turn the knurled screw (3) on
the switch.
Plus direction: Higher speed
Minus direction: Lower speed
6.3 Working with the equipment:
Important. Never hold the workpiece you wish to
sand/grind in your hand. Secure the workpiece on a
sturdy surface or with a vise.
Place the whole surface area of the sanding disk
on the material.
Switch on the machine and move it with gentle
pressure over the workpiece completely circular
movements or moving it to and fro and up and
down.
Use a coarse paper for coarse sanding and a
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Important.
The dust generated when working with the machine
may be harmful.
Always wear goggles and a dust mask when
carrying out sanding/grinding work.
Everybody who uses the machine or enters the
workplace must wear a dust mask.
Do not eat, drink or smoke at the workplace.
Do not use the machine on paints which contain
lead.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
