11
GB
쎲 For optimum trimming performance, guide the
blade teeth at an angle of approx. 15° to the
hedge (see Fig. 5).
쎲 Since the blades cut on both sides and run in
opposite directions to each other, you can trim in
both directions (see Fig. 6).
쎲 It is recommended to tie a guide line of string or
the like along the hedge so that you cut the hedge
to a level height. Cut off all branches which
protrude beyond the guide line (see Figure 7).
Ensure that the blades do not come into contact
with the string.
쎲 The sides of the hedge should be trimmed with
arc-type movements from below upwards (see
Fig. 8).
Electric brake
For safety reasons, the equipment is supplied with an
electric brake system that stops the cutting blades as
quickly as possible after the equipment has been
switched off. The equipment may therefore emit an
odor or generate sparks when it is switched off. This
has no influence on the future operational
performance or safety of the equipment. Please
avoid switching the equipment on and off more often
than necessary.
8. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
쎲 Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
쎲 We recommend that you clean the device
immediately each time you have finished using it.
쎲 Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
9.2 Maintenance
쎲 Um stets beste Leistungen zu erhalten, sollten
die Messer regelmäßig gereinigt und geschmiert
werden. Entfernen Sie die Ablagerungen mit
einer Bürste und tragen Sie einen leichten Ölfilm
auf (siehe Bild 9).
쎲 There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
10. Storage
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
11. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
12. Faults
The machine does not start: Check that the power
cable is correctly connected and check the mains
fuses. If the machine still does not work even with
connected voltage, please send it to the specified
customer services address.
