Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
10
SC BSS 7000 - 090305
Assembly page 10/24
(*)
Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
To avoid unnecessary overheating of the engine,
switch off the appliance after 30 minutes and
let it cool off for approximately 20 minutes.
In the meantime you can wash out the permanent
filters (motor filter and air filter) and replace the dust bag if necessary, but be careful not to use
the appliance when the filters are not dry! (see section “Replacing the dust bag and cleaning
the filters”). If you respect these guidelines, you will enjoy the use of this appliance for a long
time.
ASSEMBLING THE VACUUM CLEANER
• Unpack the appliance and all accessories.
• Insert the connection piece of the flexible hose into the hose connection inlet on top of
the appliance. Press until it clicks. To remove the flexible hose, press on the two release
buttons of the connection piece and pull it out of the appliance.
• Attach the handle of the hose to the telescopic tube.
• Fit the desired brush or accessory to the other end of the telescopic tube.
• You can adjust the length of the telescopic tube according to your own size.
• The floor brush is ideal for the daily cleaning of carpets and hard floors. There are two
settings on the floor brush.
- Setting with the bristles inside for cleaning carpets
- Setting with the bristles outside for cleaning hard floors
• The vacuum cleaner is delivered with the following accessories:
- Crevice tool, upholstery brush, parquet floor brush.
OPERATIONS
• When your appliance is assembled, you just need to pull out the power cord up to the
desired length. A yellow mark on the power cable shows the ideal cable length. Do not
extend the cable beyond the red mark, as this would damage the cord rewind
mechanism. Should you exceed the red mark, no guarantee claims will be accepted. Put
the plug in the power socket and switch on the appliance by pressing the ON/OFF switch
with your foot.
• You can adjust the suction power with the electronic power regulator or you can also
adjust the suction power by using the wind-force adjuster on the handle. Use a low suction
power for furniture and other delicate surfaces and use high suction power for fitted
carpet and other floors.
AFTER USE
• Stop the vacuum cleaner by pressing the ON/OFF switch.
• Unplug the appliance from the power supply.
• Simply press the cord rewind button down to activate the cable rewind mechanism.
Guide the power cord in order to prevent it from becoming entangled.
