Press
FF GG
to set, then press
HH
.
When “Auto” mode is selected:
Press
FF GG
to adjust the volume.
•Test tones are output automatically, in the order shown below.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output
switched manually.
The volume can be adjusted within the range –12 dB to +12 dB.
When “Manual” mode is selected:
Press
DD HH
to select the speaker, then press
FF GG
to
adjust the volume.
Press ENTER to finish the Test Tone setting.
2
3
-1
3
-2
4
(2 speakers)
(1 speaker)
System Setup System Setup
ENGLISH
21
ENGLISH
¢ Adjusting the test tone using the remote control
unit
Adjustment of the test tones using the remote control unit is only
possible in the “Auto” mode and only valid in the STANDARD
(Dolby/DTS Surround) mode. The adjusted levels are automatically
stored for the different surround modes.
Press [TEST TONE].
•Test tones are output from the different speakers.
Press [TEST TONE].
Press
FF GG
to adjust the volume.
1
2
3
•To adjust the channel level separately for the different play modes
after setting the channel level, perform the operation on page 36.
Input Setup
Setting the Digital In Assignment
Press
FF GG
to select “2. In”, then press ENTER.
Press ENTER or
HH
to enter the setting and switch to
the iPod Assignment setting.
Press
DD HH
to select the input terminals, then press
FF
GG
to set.
• Digital input terminal assignment not possible for “TUNER”.
• It is not possible to make the Digital In Assignment settings for the
function assigned at iPod Assignment mode.
2
1
CD, AUX, DVD, TV, VCR, V.AUX, CD-R:
Assign the different source according to the devices connected to
the AVR-587’s input terminals.
3
This assigns the different input sources for the digital input terminals.
