18
Emptying the tank/
Continous external draining
When the tank is full, the appliance stops automatically and the tank full light lights up.
Empty the tank:
1 Extract the tank slowly using the designed grip, holding the appliance firmly (fig. 2).
2 Position the handle of the tank vertically as shown (fig. 3).
3 Remove the lid (fig. 4).
4 Empty the tank (fig. 5).
5 Replace the lid and lower the handle.
6 Put the tank back in the appliance.
When the empty tank is put back, the appliance starts functioning according to the previous
settings. The tank full light goes off).
Important:
Do not remove the float inside the tank. The float is required to sense when tank is full. Replace
the lid correctly before returning the tank to the appliance.When you remove the tank, do not
touch internal parts of the dehumidifier. It could damage the appliance.
Push the tank into place carefully. If it knocks against the walls or is incorrectly inserted, the
appliance may not function. (The tank full light flashes.) Remove the tank then replace care-
fully in position.
Continuous external draining
If the appliance is to be operated for long periods but you are unable to empty the tank, it is
recommended to use the continuous drain facility.
1) Remove the rubber bung from the outlet tube (fig. 6).
2) Fasten the rubber hose to the outlet tube (fig. 7).
3) Make sure that the hose is not higher than the outlet tube, otherwise water will remain in the
tank; also check that the hose is not kinked (fig. 8).
N.B.: Keep the rubber bung. You will need it to plug the hose or close the outlet tube if you
revert to draining into the tank.
fig. 2 fig. 3 fig.4 fig.5
fig. 6 fig. 7 fig.8
