The foot controller is used for controlling the
sewing speed. The more the foot controller is
pressed, the faster the machine will sew. When
you take your foot off the foot controller, the
machine will stop automatically.
Before using the machine, practice how to
control the speed without the needle threaded.
The sewing machine is supplied with the flat
bed attached - see page 44 (Sewing with the
free arm).
The flat bed is attached to or removed from the
machine as shown in the picture.
Power switch
How to use the foot controller
6
Attention!
Before leaving the machine, changing any parts or doing any other work at the machine,
always switch off or unplug the machine from the AC outlet. Do not put anything on the foot
controller, since the machine could be started inadvertently or the foot controller or the
motor could possibly burn out.
Attaching or removing the flat bed
Please check before connecting the sewing
machine that the voltage and hertz values
indicated (230V - 50Hz) correspond with your
local voltage.
Make sure to place the sewing machine on a
solid surface. If necessary, adjust the stability of
the machine by turning the adjustment foot (25).
If you place the sewing machine on lacquered
furniture, put a nonskid pad under the machine.
Make sure that power switch (6) is set to
"0" = off. Connect the coupler plug (A) into the
connector shell and the mains plug (B) into the
wall socket.
Now the motor and light can be switched on by
turning the power switch to position I = ON.
A
B
Power switch
Off
On
