716731
3
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of
burner assembly or if you have trouble igniting grill.
1. Turn gas OFF at control knobs and LP cylinder.
2. Remove cooking grates and emitters.
3. Remove carryover tubes.
4. Detach electrode from burner.
5. Carefully lift each burner up and away from valve
openings.
We suggest three ways to clean the burner tubes. Use
the one easiest for you.
A. Bend a stiff wire (a light weight coat hanger works
well) into a small hook. Run the hook through each
burner several times.
B. Use a narrow bottle brush with a flexible handle (do
not use a brass wire brush), run the brush through
each burner tube several times.
C. Wear eye protection: Use an air hose to force air
into the burner tube and out the burner ports. Check
each port to make sure air comes out each hole.
6. Wire brush entire outer surface of burner to remove food
residue and dirt.
7. Clean any blocked ports with a stiff wire such as an open
paper clip.
8. Check burner for damage, due to normal wear and
corrosion some holes may become enlarged. If any large
cracks or holes are found replace burner.
VERY IMPORTANT: Burner tubes must re-engage valve
openings. See illustration below.
9. Attach electrode to burner.
10. Carefully replace burners.
11. Attach burners to brackets on firebox.
12. Reposition carryover tubes and attach to burners.
Replace emitters and cooking grates.
Storing Your appliance
•Clean cooking grates.
•Store in dry location.
•When gas cylinder is connected to appliance, store
outdoors in a well-ventilated space and out of reach
of children.
•Cover appliance if stored outdoors.
•Store appliance indoors ONLY if gas cylinder is turned
off and disconnected, removed from appliance and
stored outdoors.
•When removing appliance from storage check for burner
obstructions.
General appliance Cleaning
•Do not mistake brown or black accumulation of
grease and smoke for paint. Interiors of gas grills
are not painted at the factory (and should never be
painted). Apply a strong solution of detergent and
water or use a appliance cleaner with scrub brush on
insides of appliance lid and bottom. Rinse and allow
to completely air dry. Do not apply caustic
appliance/oven cleaner to painted surfaces.
Høyre
skinne
Plastic parts: Wash with warm soapy water and wipe
dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated appliance cleaner on plastic parts.
Damage to and failure of parts can result.
•Porcelain surfaces: Because of glass-like
composition, most residue can be wiped away with
baking soda/water solution or specially formulated
cleaner. Use nonabrasive scouring powder for
stubborn stains.
•Painted surfaces: Wash with mild detergent or
nonabrasive cleaner and warm soapy water. Wipe
dry with a soft nonabrasive cloth.
•Stainless steel surfaces: To maintain your
appliance’s high quality appearance, wash with mild
detergent and warm soapy water and wipe dry with
a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic
cleaning pad. Use only in direction of brushed finish
to avoid damage. Do not use abrasive pad on
areas with graphics.
• Cooking surfaces: If a bristle brush is used to clean
any of the appliance cooking surfaces, ensure no
loose bristles remain on cooking surfaces prior to
grilling. It is not recommended to clean cooking
surfaces while appliance is hot.
Clean appliance often, preferably after each
cookout. If a bristle brush is used to clean any of the
appliance cooking surfaces, ensure no loose bristles
remain on cooking surfaces prior to grilling. It is not
recommended to clean cooking surface while
appliance is hot.
appliance should be cleaned at least once a year.
IF APPLIANCE FAILS TO LIGHT
Make sure gas is turned on at cylinder.
Make sure there is gas in the cylinder.
Does the ignitor make a sparking Noise?
If yes check for spark at burner.
If no spark check for damaged or loose wires.
If wires are OK check for cracked or broken electrode,
replace if needed.
If wire or electrodes are covered by cooking residue,
clean electrode tip with alcohol wipe if needed.
If needed replace wires.
If no sound check battery.
Make sure battery is installed correctly.
Check for loose wire connection at module and switch.
If ignitor continues to not work then use match.
Leak Testing Barb, Hose and
Regulator
1. Turn all appliance control knobs to .
2. Be sure regulator is tightly connected to gas
cylinder.
3. Turn on Gas. If you hear a rushing sound, turn
gas off immediately. There is a major leak at
the connection. Correct before proceeding.
4. Brush soapy solution (mixture of half soap and
half water) onto hose connections.
Leak test before first use, at least once a
year and every time the cylinder is
changed or disconnected.
CAUTION
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER
If your barbecue is getting hard to light or the
flame is weak, check and clean the venturis and
burners.
Spiders or small insects are known to create
“flashback” problems by building nests and laying
eggs in the barbecue’s venturi or burner
obstructing the flow of gas. The backed-up gas
can ignite behind the control panel. This
flashback can damage your barbecue and cause
injury. To prevent flashbacks and ensure good
performance, the burner and venturi tube
assembly should be removed and cleaned
whenever the barbecue has been idle for an
extended period of time.
Turn controls and gas cylinder off when not in use.
3
Firebox
Carryover
tube
Electrode
Firebox
burner
bracket
Pry off electrode
with a flat blade
screwdriver
Main Burner Ignitor Lighting
Do not lean over grill while lighting.
1. Turn all control knobs to .
2. Turn ON gas at LP cylinder.
3. Open lid during lighting.
4. To ignite, push and turn burner control knob to HI.
5. Push and hold ELECTRONIC IGNITION button
until the burner lights (use flame viewing ports to
verify).
6. If ignition does NOT occur in 5 seconds, turn the
control knobs , wait 5 minutes, and repeat the
lighting procedure.
7. Ignite remaining burners by repeating steps 4 through
6 for each burner.
8. Once each burner has ignited, turn control knobs to
desired setting.
Viewing ports
Main Burner Match-Lighting
Do not lean over grill while lighting.
1. Turn all control knobs to .
2. Open lid. Turn ON gas at LP cylinder.
3. Place match into match holder (hanging from left side
of cabinet). Light match; then light burner by placing
match through the match light hole on left side of grill.
4. Push in and turn far left knob to the HI position. Once
burner has ignited (use flame viewing ports to verify),
turn control knob to desired setting.
5. If ignition does not occur in 5 seconds, turn the control
knob to , wait 5 minutes, and repeat the lighting
procedure.
6. Light adjacent burners in sequence by pushing control
knobs in and turning to the HI position.
Hot Plate Ignitor Lighting
Do not lean over grill while lighting.
1. Turn all control knobs to .
2. Open hot plate lid. Turn ON gas at LP cylinder.
3. Turn hot plate control knob to the HI position, push
and hold ELECTRONIC IGNITION button .
4. If hot plate does not light, turn control knob to ,
wait 5 minutes, and repeat the lighting procedure.
Hot Plate Match-Lighting
1. Turn all control knobs to .
2. Open hot plate lid. Turn ON gas at LP cylinder.
3. Place lit match through bottom burner pan opening at
the rear of the burner.
4. Turn hot plate control knob to the HI position. Be sure
burner lights and stays lit.
WARNING
Correct
burner-to-valve
engagement
5. If growing bubbles appear, there is a leak. Turn off
gas at cylinder immediately and check tightness of
connections. If leak cannot be stopped do not try
to repair. Call for replacement parts.
6. Always turn off gas at cylinder after performing
leak test.
Retainer
clip
Connections
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Char-Broil Platinum 3400S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Char-Broil Platinum 3400S in de taal/talen: Engels, Frans, Spaans, Deens als bijlage per email.

De handleiding is 3,15 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info