30
EN
30
•CLEANING THE PUMP FILTER
Important :
First of all drain the machine and then
disconnect the plug.
—
Remove the plinth
(Fig. 8
➀
)
and place a floor cloth
and a flat container under the access to the pump.
—
If your machine is fitted with one, remove the
purge hose.
—
Open the stopper at the end of the hose and let
the water flow into the container
(Fig. 8
➁
)
.
—
Close the stopper, ensuring that it is pushed in
well and reclip it in place.
—
Unscrew the stopper for the drain pump’s filter
(Fig. 8
➂
)
.
—
Clean the filter. To re-insert it, snap it in by
orienting the small lug on the cylindrical surface
upwards and screwing the stopper in fully
(Fig. 8
➃
)
.
—
Re-install the plinth in its original position.
Important :
When you next wash, check that there are
no leaks during filling.
•CLEANING THE DRYING FILTER
Important :
Clean this after every drying operation:
— Remove the filter from its housing (on the right,
near to the opening for the drum) and pull it towards
you
(Fig. 9)
— Clean it dry, removing any fluff it may have caught.
— Replace it in its housing, pushing it in fully.
•CLEANING THE MACHINE
—
Only use a sponge, liquid soap and water to clean
the casing, the entry to the drum, the control
panel and the products’ box, etc.
—
Never use: abrasive powders, metal or plastic
sponges, alcohol-based products, thinners, etc.
•PERIODIC CHECKS
To avoid any water damage, we recommend that
you regularly check the condition of the water and
drain hoses. If you notice the slightest cracking, do
not hesitate to replace the hoses with identical
ones available from the manufacturer or his After-
Sales Service.
•CLEANING THE PRODUCTS’ BOX
— Pull the knob forward
(Fig. 10
➀
)
, and lift the box
out
(Fig. 10
➁
)
,
— Clean everything with warm water, not forgetting
to wash the removable siphon (blue). Check that
you have replaced it correctly.
— Then re-insert the whole box, checking that it is
positioned correctly.
•REMOVING THE DRUM’S PADDLE
If an item of washing falls between the drum and
the side of the tub, empty the drum and close it.
— Turn the drum until the paddle locks.
— Unscrew the screw between the two openings
(stamped TORX. T20) and remove it. The paddle will
fall into the drum (use a terry towelling towel to
cushion its fall as a precaution).
— Turn the drum back and open it.
— Recover the fallen item through the holes
revealed by removing the paddle.
— To refit the paddle, slip it from front to back over
its support.
— Close the drum and turn it. Hold the paddle while
you re-insert the screw.
5 / MAINTAINING YOUR MACHINE
➀
8
➁
➂ ➃
ƽ
10
➀
➁
9
