53
GB
Présentation de votre lave-vaisselle
52
GB
Traces of rust on stainless
steel
A lot of drops on the
glasses
Drops on plastic glasses,
Tefal coatings, etc.
Drying is less good in
rapid programmes.
Condensation on the
walls of the inner door or
the tub.
- The quality of the stain-
less steel (in knives in
particular) is unsuitable
for washing in a machine.
- Insufficient or no rinse
aid.
- The dose has not been
distributed.
- Position of the items.
- These insulating items
have a low calorific
mass.
-
In the rapid pro-
grammes, the drying
temperature and the
drying time are reduced
to restrict the length of
the cycle to a minimum
level.
-
Condensation may form
on the walls, particular-
ly after cooling down
(sound insulation
increases its occurren-
ce).
- Use special “dishwa-
sher-safe” cutlery
- Check that the salt pot’s
stopper is firmly closed.
- Check the indicator light
and fill the reservoir
completely.
- If the reservoir is not
empty after approxi-
mately 60 washes, call
an engineer.
- To relieve the problem,
arrange the items so as
to restrict as much as
possible any water
retention: if possible,
leave the door ajar for a
few minutes.
- Arrange them optimally,
prioritising the use of
the upper basket if pos-
sible.
- Select the most appro-
priate rapid programme.
Troubleshooting, what to do?
Poor operation
Possible causes What to do
Poor washing results Possible causes What to do
Instructions for laboratory tests
✔ Washing capacity
✔ Detergent dose
✔ Detergent dispenser
✔ Setting of upper basket
(no side shelves).
✔ The water softener MUST be set to (see page
32) to deactivate the device. No salt is required.
✔ For more information on the comparison tests in
accordance with AS/NZS 2007, please contact the
manufacturer of the machine before commencing
testing.
12 IEC
standardised
place setting
30 g
of detergent
3
High position
ENERGY EFFICIENCY TESTS ACCORDING TO AS/NZS 2007
PROGRAMME : “Bio” programme
Arrange items as shown in Figures A – B – C (see IEC load on
following page)
