Fault, what to do? en
27
Appliance interior wet after
rinse cycle.
No appliance fault. On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Food remnants
on the utensils.
Utensils placed too closely
together, utensils basket
overfilled.
Arrange utensils with adequate clearance
between them ensuring that the spray jets
can reach the surface of the utensils.
Prevent contact points.
Spray arm rotation obstructed. Arrange utensils so that the spray arm can
rotate without obstruction.
Spray arm nozzles blocked. Clean the spray arm nozzles,
(See Cleaning and maintenance).
Filters 1R dirty. Clean filters, (see Cleaning and
maintenance).
Filters 1R inserted incorrectly
and/or not engaged.
Insert and engage filters correctly.
Rinse programme too weak. Select a more intensive rinse programme.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50° or
Intensive.
Tall narrow receptacles in corner
areas are not rinsed adequately.
Do not place hollow receptacles too
obliquely and do not place in the corner
area.
Top basket 1" on right and left
not set to same height.
Set top basket to same height using side
levers.
Fault Cause Remedial action
