Operating the appliance en
23
5. Press programme button # until
the factory set value ©:‹‚ is
indicated on the digital display h.
To change the setting:
1. By pressing the 3 button, you can
switch Eco drying on ©:‹‚ or off
©:‹‹.
2. Press START button `.
The set value is saved.
3. Close the door.
Notes
Eco drying is activated only in
c
onjunction with the Eco 50°
programme.
Eco drying is deactivated when
– intensive drying is switched on.
– the Eco 50° programme has
been selected in conjunction with
one or more additional functions.
– the electronic childproof lock *
has been switched on.
* depending on model
Switching on the appliance
1. Turn on the tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display h.
4. Press the START button `.
5. Close the door.
The programme starts running.
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
“Standard programme” which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Optical display while
the programme is running *
Optical display while the programme is running
* depending on model
While the programme is running,
an optical display is indicated
on the floor under the appliance door.
If the base panel is pulled forwards
or if the appliance is installed at eye-
level with flush furniture front, the display
is not visible.
Possible settings of the optical
display:
†:‹‚ is set at the factory.
†:‹‹ The display is switched off.
†:‹‚ Programme, timer programming,
remaining time, end of programme
and, if required, low water level are
displayed.
†:‹ƒ Same as †:‹‚. Other programme
information is also displayed,
e.g. the symbol for half load §
or glass protection system
active W.
