56
☞
Slide the hole cover (L) off the ventilation grille and fit it on the
opposite side.
Changing over the freezer compartment door
Open the freezer compartment door a little way.
Using a small screwdriver, press the spring in the opening of the lower
door bearing slightly upwards and take the door bearing out complete
with the door.
Position the covering cap (M) on the opposite side.
Turn the freezer compartment door through 180° and fit the
lower door bearing into the lower bearing cavity of the freezer
compartment door.
Lift the freezer compartment door a little way upwards, fit it
into the upper door bearing, and at the same time insert the
lower door bearing into the square hole.
Small upwards and downwards adjustments of the freezer
compartment door will make fitting easier.
Pannelling the door
☞
Take off the door frame section opposite to the door handle;
☞
loosen, without removing them, all remaining screws securing the door
frame;
☞
slide in the decor panel from the frameless side, then fasten again the
frame to the door including the previously removed frame section.
Note:
The overall dimensions of the decor panel must be 1 to 2 mm less than
those of the door, with a maximum thickness of 4 mm.
☞
☞
☞
☞
☞
