en Fault, what to do?
28
Refill indicator for salt )*
and/or rinse-aid )" is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt )*
and/or rinse-aid )"
is not lit.
Refill indicator switched off. Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left
in the appliance at the end
of the programme.
Filter system or area under
the filters 1R is blocked.
Clean filters and area underneath (see
Waste water pump).
The programme has not yet
ended.
Wait until programme ends or reset (see
Terminating the programme).
Utensils not dry. No or too little rinse aid
in the dispenser.
Refill rinse aid.
Programme selected without
drying.
Select programme with drying (see
Overview of programmes, Programme
sequence).
Water collecting in depressions
on the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping
as possible.
The combined detergent used
has a poor drying performance.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Intensive drying to increase
drying not activated.
Activate intensive drying (see Operating
the appliance)
Utensils were removed too early
or drying process had not ended
yet.
Wait until program ends or wait until 30 min
after program ends before removing
utensils.
The eco rinse aid used has a poor
drying performance.
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry. Cutlery not arranged properly
in the cutlery basket.
Separate cutlery if possible, prevent contact
points.
Cutlery not arranged properly
in the cutlery drawer.
Arrange cutlery properly and separate if
possible.
Fault Cause Remedial action