Handleiding Black Decker FSM1610 T1 (pagina 5 van 56) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Deens, Zweeds, Noors, Fins)

586609

Verklein

Vergroot

Pagina terug

1/56

Pagina verder

ENGLISH

(Original instructions)

Removing the carpet glider (Fig. G) (FSM1620 Only)

Caution! Always wear suitable shoes when changing the

carpet glider on your steam mop. Do not wear slippers or

open toed footwear.

u Return the handle (4) to the upright position and turn the

steam mop ‘OFF’.

u Place the steam mop on the resting mat and wait until it

cools down. (approximately ve minutes)

u Place the front of your shoe onto the carpet glider removal

tab (15) and press down rmly.

u Lift the steam mop up off the carpet glider (11).

Caution! Always place the steam mop on the resting mat (7)

with the handle (4) in the upright position when stationary and

make sure the steam mop is turned off when not in use.

Use

Important! This unit will kill 99.9% of bacteria & germs when

used in accordance with this manual and with the micro bre

pad tted and a continuous run time of 90 seconds.

Switching on and off

u To switch the appliance on, press the ON/OFF button (1).

It takes approximately 15 seconds for the steam mop to

heat up.

Note: When the steam mop is rst turned on the water res-

ervoir will glow red. Once the steam mop is ready to use the

water reservoir will glow blue.

u To switch the appliance off, press the ON/OFF button (1).

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop on

the resting mat (7) with the handle (4) in the upright position

when stationary and make sure the steam mop is turned off

when not in use.

Caution! Always empty the steam mop after use.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

Autoselect

Technology

This steam mop is tted with an Autoselect

dial (2) which

shows various cleaning applications. They are used to select

the correct operating mode for your particular cleaning opera-

tion.

Using the Autoselect

dial (2), choose from one of the follow-

ing applications:

Wood/Laminate

Stone/Marble

Tiles/Vinyl

The steam mop will select the correct volume of steam

required for your particular cleaning operation.

Note: Always check you are using the correct setting before

using your steam mop.

Hints for optimum use

General

Caution! Never use the steam mop without rst attaching a

cleaning pad.

u During use you can use the cable management clip (10) to

keep your cable out of the way of the work area..

u Always vacuum or sweep the oor before using the steam

mop.

u The easiest way to use the machine is to tilt the handle to

a 45˚ angle and clean slowly, covering a small area at a

time.

u Do not use chemical cleaners with your steam mop. To

remove stubborn stains from vinyl or linoleum oors, you

can pre-treat with a mild detergent and some water before

using the steam mop.

Steam cleaning

u Place a cleaning pad (6) on the oor with the ‘hook & loop’

side facing up.

u Raise the steam mop off the resting mat (7) and lightly

press it down onto the cleaning pad (6).

u Place the steam mop on the resting mat.

u Connect the steam mop to the mains.

u Turn the Autoselect

dial (2) to the required setting.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Pulling the handle (4) back will activate the steam pump.

After a few seconds steam will start to come out of the

steam head.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

u It takes a few seconds for steam to enter the cleaning pad.

The steam mop will now glide easily over the surface to be

sanitised/cleaned.

u Push and pull the steam mop slowly across the oor to

thoroughly steam clean each section.

Note: During use you may turn off the steam pump by return-

ing the handle to the upright position, this convenient feature

will allow you to place the steam mop on the resting mat for

a short time so that you may move items of furniture, then

continue cleaning without the need to switch the appliance off.

u When you have nished using the steam mop, return the

handle (4) to the upright position and turn it ‘OFF’, place it

on the resting mat (7) and wait until the steam mop cools

down. (approximately ve minutes)

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Black Decker FSM1610 T1 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Black Decker FSM1610 T1

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info