PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS.
With proper care and use, this Bionaire™ air purifier
will give you fresh, clean air for many years.
NOTE: Before reading these instructions, please
unfold the back page for the corresponding
illustrations.
DESCRIPTIONS (SEE FIG 1/2/3)
A. SPEED CONTROL KNOB
B. FILTER LIFE INDICATOR
C. RESET BUTTON (not shown)
D. POWER CORD (not shown)
E. FILTERED AIR OUTLET
F. AIR INTAKE GRILL
G. CARBON FILTER
H. HEPA FILTER
I. HANG TABS
SAFETY PRECAUTION
Carefully read and retain all instructions before
using the air purifier.
• To avoid fire or shock hazard, check that the
voltage on the product corresponds to your
electricity supply and plug directly into an
electrical outlet.
• To avoid fire hazard, never put the cord under
rugs, or near any heat source.
• Carefully discard any plastic wrapping that
was used for the packaging.
• Do not use the air purifier outside.
• Do not place the unit near any heat source or
in direct sunlight.
• Always unplug the air purifier before removing
the grill, changing the filters, cleaning the air
purifier or whenever it is not in use.
• Do not use in or around water or any other
liquids. Do not attempt to wash the unit under
running water.
• Use appliance only for intended household use
as described in this manual.
• Ensure that all air openings are not restricted
or covered in any way.
• Do not place anything on top of the unit.
• Never insert any object into any openings.
• Do not use the air purifier if any part is missing
or damaged in any way.
• Do not attempt to repair or adjust any mechanical
functions of this unit. If the unit becomes damaged
return to the place of purchase or phone the
helpline number on the back of this leaflet.
HOW THE AIR PURIFIER WORKS
Dirty, dust laden air is drawn through the front of
the air purifier and through the multi-stage
filtration system.
1. The carbon filter will help clear odours making
the air cleaner and fresher.
2. The HEPA filter entraps 99.97% of all smaller
visible and non-visible particles down to 0.3
microns in size.
PRODUCT FEATURES
Dual position
The unit can be placed either upright or on its side,
flush against the wall. When positioning the unit
be sure that the air inlet grill, filters and air outlet
grill are not blocked, to ensure maximum air flow.
FILTER LIFE INDICATOR
Filter Window
On the front grill, there is a small opening that will
enable you to see your carbon filter at a glance.
As it picks up dust and debris, the window will turn
to gray indicating the air purifier is working and
you may need to change the carbon filters.
HEPA Filter Indicator
When the HEPA filter is approaching the end of
its useful life, the indicator light will turn red.
When the red indicator light starts flashing, it is
time to change the HEPA filter.
Carbon Filter Indicator
When the carbon filter indicator light turns yellow,
it is time to change the carbon filter.
Timer
The timer allows you to run your air purifier at
your convenience, for up to 16 hours. To operate
using the timer mode, at the control panel on the
air purifier, turn the unit on and select a speed.
To activate the timer, press the up and down
speed buttons at the same time for approximately
3 seconds.
The numbers in the display will begin flashing and
the green LED light will appear to indicate timer
function is on. Push “+” or “-” button to cycle through
the timer options (1- 16). When you have reached
desired hours that you want your air purifier to run,
release finger from the button and the numbers
will stop flashing and timer will be on. The air
purifier will then operate for that period of time
and shut off automatically. Speeds can be changed
once the timer is activated by pushing the “+” or
“-“ buttons. To view the time left to run once timer
has been set, push the “+” and “-“ at the same time
for 3 seconds. You can manually turn the air purifier
off by pressing the ON/OFF button once.
U.K. and IRELAND
PRE-OPERATING INSTRUCTIONS
NOTE: The front grill should not be opened when
the unit is on its side.
1. After removing the unit from the box, remove
the plastic covering from the unit.
2. Place unit with air intake grill pointing upwards.
3. Open the front grill of the air purifier.
4. Remove protective plastic bag from carbon filters
before placing on HEPA filters. The plastic tabs
on the HEPA filter will hold the carbon in place
(fig.2)
5. Insert the filter(s) into the unit by sliding onto
the hang tabs (fig 3).
6. Replace the front grill by aligning tab on left
hand side and swinging down. Gently press
until front till grill is firmly in place.
OPERATING
1. Select a location where the air intake grill and
filtered air outlet grill are not obstructed.
2. Plug into a suitable electrical outlet.
3. Select the required air speed setting: High (4),
Medium (3), Low (2), Sleep (1) by pushing the
"+" or "-" buttons on the control panel. (On will
automatically cycle to the highest setting.)
4. For optimum air filtration, it is recommended
to operate the air purifier continuously.
Its rugged motor is designed to give many
years of service.
5. For continuous use it is recommended to operate
the air purifier at the Medium (3) setting.
For quieter operation or use in a bedroom,
select the Low (2) setting or Sleep(1) setting.
When high levels of air polution are present,
select the HI (4) setting to quickly circulate
clean filtered air.
CLEANING AND MAINTENANCE
1. Turn the air purifier off and unplug it before cleaning.
2. The outside of the air purifier can be cleaned
with a soft, clean dampened cloth.
3. The filtered air outlet on the top of the unit can
be cleaned of dust with a small, soft brush.
4. If you wish to clean the inside of the air purifier,
please only use a dry, soft cloth to wipe it down.
FILTER REPLACEMENT
BAP725 takes two HEPA filters and two carbon filters.
IN ORDER TO MAINTAIN THE MAXIMUM BENEFIT
FROM YOUR AIR PURIFIER, YOU WILL NEED
TO REPLACE THE FILTERS WHEN INDICATED
BY THE FILTER LIFE INDICATOR OR AT THE
RECOMMENDED INTERVALS (SEE BELOW).
HEPA filters need to be replaced every 6-12 months.
Carbon filters need to be replaced every 2-3 months.
Filter life will vary depending on air quality and usage.
1. Turn off and unplug the air purifier before
attempting to replace filters.
2. Remove each of the filters from the unit by
pulling gently towards you.
3. To replace the carbon filter(s), simply remove
the old carbon filter(s) and insert new carbon
filter(s) in place, using the plastic tabs as a
guideline (see fig. 1)
4. To replace the HEPA filter(s), remove and discard
the old HEPA filter(s).
Attach the carbon filter onto the new HEPA filter
using the plastic tabs as a guideline (see fig. 2).
Insert the filter(s) into the unit by sliding onto
the hang tabs (fig 3).
5. After replacing the HEPA filter(s), RESET the
Filter Life Indicator by inserting a small object
(such as a pin or paper clip) into the hole marked
RESET.
REPLACEMENT FILTERS
BAPF600 HEPA Filter
BAPF60 Carbon Filter
THIS AIR PURIFIER HAS BEEN TESTED IN
ACCORDANCE WITH THE SAFETY
STANDARDISED TESTS REQUIRED BY THE 73/23
EEC DIRECTIVE, 89/336 EEC DIRECTIVE AND
98/37/EEC DIRECTIVE.
Installation of a plug Applicable to U.K.
and Ireland.
WARNING - THIS APPLIANCE MUST BE
EARTHED
The wires in the mains lead are coloured as such:
GREEN AND YELLOW - EARTH
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires
may not correspond with the colour markings
that identify the terminals in your plug. Please
proceed as follows:
The wire which is coloured GREEN AND YELLOW
must be connected to the terminal which is marked
with the letter 'E' or with the earth symbol
The BROWN coloured wire must be connected
2
3