541771
7
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
SVT-7 PRO Bass Guitar Amplifier
SVT-7 PRO Bass Guitar Amplifier SVT-7 PRO Bass Guitar Amplifier
7
19. IEC POWER INPUT CONNECTOR: This
is where you connect the supplied AC
power cord.
Before plugging in the power cord, make
sure that the voltage selector switch is
set to the same voltage as your local AC
mains.
20. VOLTAGE SELECTOR SWITCH:
Make sure the switch is in the correct
position for your local AC mains voltage
before you plug in the AC power cord.
Use a small flat screwdriver to slide the
switch if required.
21. VENTILATION: Make sure that the
ventilation openings are not obscured in
any way. This will allow the flow of
cooling air to the power amplifier’s
heatsinks.
22. SPEAKER OUTPUTS: These Neutrik /
1/4" TS output jacks supply
speaker-level power to the speaker
cabinet. The rated power output is 600
watts rms into 8 ohms or 1000 watts
rms into 4 ohms.
The two identical outputs are wired in
parallel, and you can use either one, or
use both. Make sure the total speaker
impedance load is 4 ohms or greater.
For example, you could connect:
Two 16 ohm speakers (an 8 ohm load),
Two 8 ohm speakers (a 4 ohm load)
or one 4 ohm speaker.
Use speaker cables with Neutrik or 1/4"
TS ends to make the connections. Do
not use instrument cables as they may
overheat.
23. TUBE DIRECT OUTPUT: Typically, you
would connect this balanced output to
the balanced input of an external mixer,
or a recorder. In this way, you do not
have to mic the speaker cabinet in order
to add it to the main mix, or to record.
The output is not affected by the master
control.
This output can connect to external
power amplifiers, or powered
loudspeakers, as long as they have their
own input controls to adjust the volume
level.
Balanced connections allow long cable
runs to be used, as hum and noise
pickup in the line is minimized.
24. GROUND / LIFT: Press this switch in to
engage the Ground Lift, if necessary, to
help eliminate hum at the XLR jack.
25. 0dB (line level) / -40dB (mic level):
Press this switch in to apply a 40 dB cut
to the signal at the Tube Direct Output.
19 20 21 22 23 24
2930313233
25
26
27
28
The Rear Panel
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ampeg SVT-7 Pro bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ampeg SVT-7 Pro in de taal/talen: Engels als bijlage per email.

De handleiding is 1,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info