541358
21
Verklein
Vergroot
Pagina terug
1/40
Pagina verder
Allen & Heath 21 XB-14 User Guide
8
9
10
7
9
10
LR
BAL
=
SIGNAL
PFL
PEAK
OO +6
PRE
PGM
FDR
BUS
AUX
0
5
10
15
20
30
40
50
OO
MIX B
+START/CUE
STEREO INPUT CHANNELS ST1 & ST2
FOR CLARITY ONLY ST1 CHANNEL IS DESCRIBED HERE
7
BAL
The balance control adjusts the relative levels of the left & right signals in
the stereo input channel as they are sent to the PGM bus and the MIX B
bus. Set to the mid position, the signals are balanced equally. With the
balance control set fully anticlockwise the right channel will be fully at-
tenuated and the left channel will increase by approximately 3.5dB.
ON (+START/CUE) switch
The stereo channel ON switch operates the stereo channel mute cir-
cuitry, turning the signals to the PGM, MIX B and Aux buses on or off.
The switch is illuminated green when pressed.
The ON switch also activates the START/CUE logic signals (for the cor-
responding selected input) wired to the remote interface connector on
the rear panel.
There is an option to disable the mute circuit on all the stereo channels
(make the channels permanently ON) using the option switches on the
rear panel. This can be done for all 4 stereo channels together, retaining
the illumination switching (if the ON switch is being used for Start/Cue).
It can also be done on an individual channel basis by using the STEREO
INPUTS 1,2,3&4 slide switches in which case the illumination of the
switch will be jammed permanently ON.
8
SIGNAL & PEAK LEDs
The Signal LED illuminates when the pre-fader L or R signal level is above
–15dB.
The Peak LED illuminates and stays on for around 0.5 seconds when a
peak level is detected (pre-fader signal) within 5dB of clipping.
PFL Switch
Sends the summed L & R stereo channel signals to the PFL bus.
Fader
The 100mm fader controls the level of the stereo channel L & R signals
to the PGM bus, MIX B bus and post fade Aux.
There is no fader start logic feature on the stereo channel faders.
11
11
ON ON ON ON ON ON ON ON ON ON ON ON
MONO INPUTS
1234 T1T212 34
STEREO INPUTS
)
ON Switch Not Pressed ON Switch Pressed
Channel Muted
ON ON ON ON ON ON ON ON ON ON ON ON
MONO INPUTS
1234 T1T212 34
STEREO INPUTS
)
Channel ON
Channel ON
Channel ON
Standard
Operation
STEREO
ON Switch
Optional
Modes
Mute
Disabled
(Always ON)
LEDs FOLLOW
SWITCH
(All stereos)
ON ON ON ON ON ON ON ON ON ON ON ON
MONO INPUTS
1234 T1T212 34
STEREO INPUTS
)
Channel ON Channel ON
Mute
Disabled
(Always ON
All Stereos)
LEDs always
illuminated
(On ST1 only)
CUE Deck START Deck
CUE Deck
START Deck
START Deck
CUE Deck
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Allen-Heath XB-14 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Allen-Heath XB-14 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info