20
Training
1. Set the wireless alarm system / wireless receiver to
learning mode. See the receiver instructions for more
details.
2. Wireless variations:
Activate the tamper contact of the wireless glass
breakage detector to send a tamper message to the
wireless alarm system.
IR variation:
Point the LED of the glass breakage detector at the IR
receiver of the wireless extension (RFX). Trigger the
tamper contact of the glass breakage detector.
3. Make sure that the glass breakage detector is
recognised by your wireless alarm system / wireless
receiver, then close the housing.
Walk test
1. Switch the alarm system to walk test mode (see the
relevant installation instructions).
2. Test whether the detector and the LED are working by
clapping loudly. The LED flashes twice.
3. Use a glass breakage simulator to check the response
of the detector. The LED lights up for a few seconds.
The detector now sends an alarm signal to the alarm
centre.